Alcatel-Lucent OmniSwitch 6250 - Show 802.1 Q

802.1Q Commands
page 15-6 OmniSwitch 6250 CLI Reference Guide November 2009
show 802.1q
Displays 802.1Q tagging information for a single port or an aggregate of ports.
show 802.1q {slot/port | aggregate_id}
Syntax Definitions
slot The slot number to display 802.1Q tagging.
port The port number to display 802.1Q tagging.
aggregate_id The link aggregation ID to display 802.1Q tagging. See Chapter 12,
“Link Aggregation Commands” for more information on link aggrega-
tion.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show 802.1q 3/4
Acceptable Frame Type : Any Frame Type
Force Tag Internal : off
Tagged VLANS Internal Description
-------------+-------------------------------------------------+
2 TAG PORT 3/4 VLAN 2
-> show 802.1q 2
Tagged VLANS Internal Description
-------------+-------------------------------------------------+
3 TAG AGGREGATE 2 VLAN 3
Output fields are described here:
output definitions
Acceptable Frame Type The acceptable frame type for this port, which can be Any Frame
Type or Tagged Only Frame Type.
Force Tag Internal This field displays if adding the default VLAN ID (VID) to tagged
frames is turned on or off.