IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-61
show ipv6 redist
Displays the IPv6 route map redistribution configuration.
show ipv6 redist [rip]
Syntax Definitions
rip Displays the route map redistribution configurations that specify RIP as
the destination (into) protocol.
Defaults
By default all route map redistribution configurations are shown.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Specify a destination protocol with this command to display only those configurations that redistribute
routes into the specified protocol.
• The IPv6 version of BGP is not supported currently.
Release History
Release 6.6.1; command was introduced.
Examples
-> show ipv6 redist
Source Destination
Protocol Protocol Status Route Map
------------+------------+---------+--------------------
localIPv6 RIPng Enabled ipv6rm
output definitions
Source Protocol The protocol from which the routes are learned.
Destination Protocol The protocol into which the source protocol routes are redistributed..
Status The administrative status (Enabled or Disabled) of the route map
redistribution configuration.
Route Map The name of the route map that is applied with this redistribution
configuration.
To Next Page
Loading...
