802.1X Commands
page 44-24 OmniSwitch 6250 CLI Reference Guide November 2009
802.1x captive-portal address
Configures a different subnet for the Captive Portal IP address (10.123.0.1).
802.1x captive-portal address ip_address
Syntax Definitions
address The IP address for the Captive Portal login page. This IP address must
use the following octet values: 10.x.0.1, where “x” is used to specify a
new subnet value.
Defaults
By default, the Captive Portal IP address is set to 10.123.0.1.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If the 10.123.0.1 subnet is already in use on the network, use this command to change the second octet
of this IP address. Note that the second octet is the only configurable part of the Captive Portal IP
address that is allowed.
• This IP address is used exclusively by the Captive Portal feature to serve various pages and to assign a
temporary IP address for a client device that is attempting web-based authentication.
Examples
-> 802.1x captive-portal address 10.11.0.1
-> 802.1x captive-portal address 10.124.0.1
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDot1xCportalConfig
alaDot1xCPortalIpAddress
show 802.1x captive-portal
configuration
Displays the global Captive Portal configuration for the switch.
To Next Page
Loading...
