Session Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 6-7
session timeout
Configures the inactivity timer for a CLI, HTTP (including WebView), or FTP interface. When the switch
detects no user activity for this period of time, the user is logged off the switch.
session timeout {cli | http | ftp} minutes
Syntax Definitions
cli Sets the inactivity timeout for CLI sessions.
http Sets the inactivity timeout for HTTP sessions.
ftp Sets the inactivity timeout for FTP sessions.
minutes Inactivity timeout value (in minutes). Valid range 1 to 596523.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The inactivity timer value may be different for each type of interface, such as CLI (Console, Telnet),
HTTP (including WebView), and FTP.
• If you change the timer, the new value does not affect current sessions; the new timer is applied to new
sessions only.
Examples
-> session timeout cli 5
Release History
Release 6.6.1; command was introduced.
parameter default
minutes 4
To Next Page
Loading...
