IP Commands
page 29-46 OmniSwitch 6250 CLI Reference Guide November 2009
ip route-map set tag
Configures the tag value of the route being distributed.
ip route-map route-map-name [sequence-number number] set tag tag-number
no ip route-map route-map-name [sequence-number number] set tag tag-number
Syntax Definitions
route-map-name The name of the route map (up to 20 characters).
number A number that links together the route maps. The range is 1–100.
tag-number Configures the tag number.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to delete the set tag parameter in the route map.
• All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
• The route-map-name and sequence-number should exist before you configure this set criteria.
Examples
-> ip route-map 111 sequence-number 50 set tag 23
-> no ip route-map 111 sequence-number 50 set tag 23
Release History
Release 6.6.1; command was introduced.
Related Commands
parameter default
number 50
ip route-map action Creates a route map for redistribution and sets the status of the route
map to permit or deny.
show ip route-map Displays the configured IP route maps.
To Next Page
Loading...
