Alcatel-Lucent OmniSwitch 6250 - Show Ethernet-Service Port

VLAN Stacking Commands
OmniSwitch CLI Reference Guide November 2009 page 24-37
show ethernet-service port
Displays configuration information for a VLAN Stacking service port.
show ethernet-services port {slot/port | linkagg agg_num}
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
agg_num The link aggregate ID number (0–31).
Defaults
N/A
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
Specifying a slot/port or link aggregate ID number is required with this command.
Examples
-> show ethernet-service port 1/10
Interface : 1/10
Port Type : UNI
UNI Profile : default-uni-profile
Default SVLAN : 4095
Service Name : ipmv_service
IPMVLAN : 40
NNI(s) : No NNIs configured
SAP Id : 2
UNIs : 1/10
CVLAN(s) : 100
sap-profile : translate_profile
Service Name : svlan_service
SVLAN : 20
NNI(s) : No NNIs configured
SAP Id : 1
UNIs : 1/10
CVLAN(s) : 200
sap-profile : translate_profile