Source Learning Commands
page 18-16 OmniSwitch 6250 CLI Reference Guide November 2009
show mac-address-table count
Displays Source Learning MAC Address Table statistics.
show mac-address-table count [mac_address] [slot slot | slot/port] [linkagg link_agg] [vid | vid1-vid2]
Syntax Definitions
mac_address MAC Address (e.g., 00:00:39:59:f1:0c).
slot | slot/port Slot number for the module or the slot number and the physical port
number on that module (e.g., 3/1 specifies port 1 on slot 3).
link_agg Enter a link aggregate ID number (0–31). See Chapter 12, “Link Aggre-
gation Commands.”
vid VLAN ID number (1–4094).
Defaults
By default, the count statistics are displayed for all MAC addresses contained in the MAC address table.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• To display statistics for all ports on one slot, specify only the slot number for the slot parameter value.
• Note that only one VLAN entry—a single VLAN ID or a range of VLAN IDs— is allowed with this
command. Multiple entries are not accepted.
Examples
-> show mac-address-table count
Mac Address Table count:
Permanent Address Count = 1
DeleteOnReset Address Count = 0
DeleteOnTimeout Address Count = 0
Dynamic Learned Address Count = 6
Total MAC Address In Use = 7
-> show mac-address-table count 10-20
Mac Address Table count:
Permanent Address Count = 0
DeleteOnReset Address Count = 0
DeleteOnTimeout Address Count = 0
Dynamic Learned Address Count = 28
Total MAC Address In Use = 28
To Next Page
Loading...
