Chassis Management and Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 2-43
show module long
Displays the detailed information for either a specified module or all the modules installed in a standalone
switch chassis or a stack. Modules include switches performing the primary and secondary CMM roles
and Network Interface (NI) in a stack.
show module long [number]
Syntax Definitions
number The slot number for a specific module installed in a standalone switch
chassis or the switch number within a stack. If no slot number is speci-
fied, detailed information for all the modules is displayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• When a particular NI module is specified in the command line, output is the same as that of the
show ni command.
• This command may be used when logged into the switch that performs either the primary or secondary
CMM role in a stack.
Examples
-> show module long
CMM in slot 1
Model Name: OS6250-24,
Description: 10/100/1000,
Part Number: 902271-10,
Hardware Revision: 002,
Serial Number: E23L9059,
Manufacture Date: JUN 08 2004,
Firmware Version: N/A,
Admin Status: POWER ON,
Operational Status: UP,
Power Consumption: 0,
Power Control Checksum: 0x0,
MAC Address: 00:d0:95:a3:e5:09,
Module in slot 1
Model Name: OS6250-24,
Description: 10/100/1000,
Part Number: 902271-10,
Hardware Revision: 002,
Serial Number: E23L9059,
Manufacture Date: JUN 08 2004,
Firmware Version: N/A,
To Next Page
Loading...
