Link Aggregation Commands
page 12-28 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg actor system priority
Configures the system priority of the port on the switch that belongs to the dynamic aggregate group.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port actor system priority actor_system_priority
lacp agg [ethernet | fastethernet | gigaethernet] slot/port
no actor system priority
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
actor_system_priority The priority of the dynamic aggregate group. Possible values are
0–255.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an actor system priority value from a slot and port associ-
ated with a dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg ethernet 3/2 actor system priority 65
-> lacp agg ethernet 3/2 no actor system priority
Release History
Release 6.6.1; command was introduced.
parameter default
actor_system_priority 0
To Next Page
Loading...
