Ethernet OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 25-41
show ethoam domain association end-point
Displays the information of a specific MEP in a Management Domain configured on the bridge.
show ethoam domain {domain_name | mac_address} association association_name end-point
endpoint_id
Syntax Definitions
domain_name Specifies the domain name.
mac_address Specifies the CFM system MAC address.
association_name Name of the Ethernet OAM Association.
endpoint_id Specifies the MEP of a specific MA. The valid range is 1–8191.
Defaults
N/A
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
N/A
Examples
-> show ethoam domain esd.alcatel-lucent.com association alcatel-sales endpoint 3
Admin State : up,
Direction : up,
Slot/Port: 1/2,
MacAddress: 00:D0:95:EC:84:B0,
Fault Notification : FNG_RESET,
CCM Enabled : enabled,
CCM Linktrace Priority : 7,
CCM Not Received : false,
CCM Error defect : false,
CCM Xcon defect : false,
MEP RDI defect : false,
MEP Last CCM Fault : not specified,
MEP Xcon Last CCM Fault : not specified,
MEP Error Mac Status : false,
MEP Lbm NextSeqNumber : 0,
MEP Ltm NextSeqNumber : 13357,
Fault Alarm Time : 250,
Fault Reset Time : 1000,
Lowest PrDefect Allowed : DEF_MAC_REM_ERR_XCON,
Highest PrDefect Present : DEF_NONE
To Next Page
Loading...
