VLAN Stacking Commands
OmniSwitch CLI Reference Guide November 2009 page 24-21
ethernet-service sap sap-profile
Associates a VLAN Stacking Service Access Point (SAP) with a SAP profile. This command is also used
to change an existing SAP profile association.
ethernet-service sap sapid sap-profile sap-profile-name
Syntax Definitions
sapid The SAP ID number (2–4094).
sap-profile-name The name of the SAP profile to associate with this SAP ID.
Defaults
The “default-sap-profile” profile is automatically associated with the SAP ID when the SAP is created.
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
• If a profile association already exists for the specified SAP ID, the current profile is replaced with the
profile specified with this command.
• The SAP ID specified with this command must already exist. Use the ethernet-service sap command
to create a SAP.
• The SAP profile specified with this command must already exist. Use the ethernet-service sap-profile
command to create a SAP profile.
• To change the profile associated with the SAP back to the default profile, enter “default-sap-profile”
with this command.
• Note that if the SAP ID specified with this command is associated with an IPMVLAN, the profile asso-
ciated with the SAP ID must specify CVLAN tag translation. Double tagging is not supported with
IPMVLAN SAPs that are also associated with a UNI port.
• Do not specify a service name; doing so will return an error message. This command is only for associ-
ating an existing profile to a VLAN Stacking SAP.
Examples
-> ethernet-service sap 10 sap-profile CustomerC
-> ethernet-service sap 11 sap-profile CustomerD
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
