Learned Port Security Commands
page 19-2 OmniSwitch 6250 CLI Reference Guide November 2009
port-security
Enables or disables Learned Port Security (LPS) on the switch port(s). When LPS is enabled, only devices
that have a source MAC address that complies with LPS restrictions are learned on the port(s).
port-security slot/port[-port2] [enable | disable]
port-security chassis disable
no port security slot/port[-port2]
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
-port2 The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
enable Enables LPS on the specified port(s).
disable Disables LPS on the specified port(s).
chassis disable Disables all LPS-eligible ports on the chassis.
Defaults
By default, LPS is disabled on all switch ports.
Platforms Supported
OmniSwitch 6250
parameter default
enable | disable enable
To Next Page
Loading...
