Switch Logging Commands
page 45-10 OmniSwitch 6250 CLI Reference Guide November 2009
show log swlog
Displays stored switch logging information.
show log swlog
show log swlog [session session_id] [timestamp start_time [end_time]] [appid appid] [level level]
Syntax Definitions
session_id Identification number of the session for which switch logging
information is displayed.
start_time Specify the starting time for the switch logging information to be
displayed. Use the format mm/dd/yyyy hh:mm where mm represents the
month, dd is the day, yyyy is the year, hh is the hour, and mm is the
minutes. Use four digits to specify the year.
end_time Specify the ending time for the switch logging information to be
displayed. Use the format mm/dd/yyyy hh:mm where mm represents the
month, dd is the day, yyyy is the year, hh is the hour, mm is the minutes.
Use four digits to specify the year.
appid A digit that represents the application ID for the switch logging
information to be displayed. Values are listed in the following table.
Supported Application IDs and their Numeric Equivalents
802.1q - 7
aaa - 20
amap - 18
bridge - 10
chassis - 64
cli - 67
config - 66
dbggw - 89
diag - 0
distrib - 84
drc - 74
eipc - 26
epilogue - 85
ftp - 82
gmap - 19
health - 76
idle - 255
interface - 6
ip - 15
ipc-diag - 1
ip-helper - 22
ipc-link - 4
ipc-mon - 21
ipms - 17
ldap - 86
linkagg - 12
mipgw - 70
module - 24
nan-driver - 78
ni-supervision - 5
nosnmp - 87
pmm - 23
policy - 73
port-mgr - 64
psm - 81
qdispatcher - 3
qdriver - 2
qos - 13
rmon - 79
rsvp - 14
session - 71
smni - 83
snmp - 68
ssl - 88
stp - 11
system - 75
telnet - 80
trap - 72
vlan - 8
web - 69
To Next Page
Loading...
