IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-47
ipv6 multicast static-group
Creates a static MLD group entry on a specified port on a specified VLAN.
ipv6 multicast static-group ip_address vlan vid port slot/port
no ipv6 multicast static-group ip_address vlan vid port slot/port
Syntax Definitions
ip_address IPv6 multicast group address.
vid VLAN to include as a static MLD group.
slot/port The slot/port number you want to configure as a static MLD group.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an MLD static group entry on a specified port on the spec-
ified VLAN.
• The ipv6 multicast static-group command allows you to create an MLD static group entry on a speci-
fied port on a specified VLAN. This, in turn, enables that network segment to receive MLD traffic
addressed to the specified IPv6 multicast group address.
• You can also create an MLD static group entry on a link aggregate port by entering
ipv6 multicast static-group ip_address vlan vid port, followed by the link aggregation group number
(e.g., ipv6 multicast static-group ff05::5 vlan 2 port 7).
Examples
-> ipv6 multicast static-group ff05::4681 vlan 4 port 1/1
-> no ipv6 multicast static-group ff05::4681 vlan 4 port 1/1
-> ipv6 multicast static-group ff05::4681 vlan 4 port 7
-> no ipv6 multicast static-group ff05::4681 vlan 4 port 7
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
