Alcatel-Lucent OmniSwitch 6250 - Ipv6 Multicast Static-Neighbor

IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-43
ipv6 multicast static-neighbor
Creates a static MLD neighbor entry on a specified port on a specified VLAN.
ipv6 multicast static-neighbor vlan vid port slot/port
no ipv6 multicast static-neighbor vlan vid port slot/port
Syntax Definitions
vid VLAN to include as a static MLD neighbor.
slot/port The slot/port number you want to configure as a static MLD neighbor.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an MLD static neighbor entry on a specified port on a
specified VLAN.
• The ipv6 multicast static-neighbor command allows you to create an MLD static neighbor entry on a
specified port on a specified VLAN. This, in turn, enables that network segment to receive all MLD
traffic.
• You can also create an MLD static neighbor entry on a link aggregate port by entering
ipv6 multicast static-neighbor vlan vid port, followed by the link aggregation group number
(e.g., ipv6 multicast static-neighbor vlan 2 port 7).
Examples
-> ipv6 multicast static-neighbor vlan 4 port 1/1
-> no ipv6 multicast static-neighbor vlan 4 port 1/1
-> ipv6 multicast static-neighbor vlan 4 port 7
-> no ipv6 multicast static-neighbor vlan 4 port 7
Release History
Release 6.6.1; command was introduced.