EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6250 - 802.1 X Non-Supplicant Policy

Alcatel-Lucent OmniSwitch 6250
2018 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
802.1X Commands
page 44-14 OmniSwitch 6250 CLI Reference Guide November 2009
802.1x non-supplicant policy
Configures a non-supplicant device classification policy for an 802.1x port. This type of policy does not
perform any authentication. A non-supplicant is a device that does not support using the 802.1x protocol
for authentication.
802.1x slot/port non-supplicant policy {group-mobility | vlan vid | default-vlan | block | captive-
portal}
Syntax Definitions
slot/port The slot and port number of the 802.1x port.
group-mobility Use Group Mobility rules for device classification.
vlan vid Use this VLAN ID number for device classification.
default-vlan Assign supplicant to the default VLAN for the 802.1x port.
block Block supplicant traffic on the 802.1x port.
captive-portal Use Captive Portal for web-based device classification.
Defaults
By default no device classification policies are configured for an 802.1x port.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Because this policy does not use 802.1x or MAC authentication, non-supplicants are only classified for
assignment to non-authenticated VLANs.
Note that if a non-supplicant policy is not configured for an 802.1x port, then non-supplicants are auto-
matically blocked from accessing the port.
If the captive-portal parameter is specified with this command, then the Captive Portal authentication
policy is applied to non-supplicant traffic. See the 802.1x captive-portal policy authentication
command page for more information.
Configuring non-supplicant classification policies is only supported on 802.1x enabled mobile ports.
Each 802.1x port can have one supplicant policy and one non-supplicant policy for handling 802.1x
and non-802.1x devices, respectively. Configuring a new supplicant or non-supplicant policy over-
writes any policies that may already exist for the port.
Examples
-> 802.1x 4/1 non-supplicant policy group-mobility default-vlan
-> 802.1x 5/10 non-supplicant policy vlan 500 block
-> 8022.1x 6/1 non-supplicant policy group-mobility vlan 247 block
-> 802.1x 4/10 non-supplicant policy captive-portal

Table of Contents

Other manuals for Alcatel-Lucent OmniSwitch 6250

Related product manuals