AAA Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 43-77
debug command-info
Enables or disables the command information mode in the CLI. When this mode is enabled, any command
entered on the command line will display information about the command rather than executing the
command.
debug command-info {enable | disable}
Syntax Definitions
enable Enables the debugging command information mode.
disable Disables the debugging command information mode.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• When the mode is enabled, any command entered will result in output similar to the one shown in the
Examples section below. Any commands entered when the mode is enabled are not executed. To return
to normal operating mode, enter debug command-info disable.
• The command information mode is useful when setting privileges for users.
Examples
-> debug command-info enable
CLI command info mode on
-> vlan 2
PM family: VLAN
R/W mode: WRITE
-> ls
PM family: SYSTEM
R/W mode: READ
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
output definitions
PM family The partitioned management (PM) command family to which the com-
mand belongs.
R/W mode Whether the current command is a read-only or a write command.
To Next Page
Loading...
