UDLD Commands
page 27-12 OmniSwitch 6250 CLI Reference Guide November 2009
interfaces clear-violation-all
Brings the port out of shutdown state.
interfaces slot/port[-port2] clear-violation-all
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
port2 The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
Defaults
N/A
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
• If any interface is in the admin down state because of UDLD, then the status of the interface can be
confirmed using the show interfaces port command. The violation field indicates the reason of viola-
tion.
• The port may again go into shutdown state if the UDLD operation determine that UDLD violation is
still not cleared.
Examples
-> interfaces 1/8 clear-violation-all
-> interfaces 1/10-14 clear-violation-all
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaUdldPortStatsTable
alaUdldPortStatsClear
show interfaces port Displays interface port status (up or down).
To Next Page
Loading...
