Loopback Detection Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 17-7
show loopback-detection
Displays the global LBD configuration information for the switch.
show loopback-detection
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
• Use this command to display the global configuration of LDB.
• To view information for a specific port, use the show loopback-detection port command.
Examples
-> show loopback-detection
Global LBD Status : Enabled
Global LBD Transmission Timer : 200 sec
Global LBD Auto-recovery Timer : 300 sec
-> show loopback-detection port 1/1
Global LBD Status : Enabled
Global LBD Transmission Timer : 200 sec
Global LBD Auto-recovery Timer : 300 sec
Port LBD Status : Enabled
Port LBD State : Normal
output definitions
Global LBD Status The current status of LBD of the switch (Enabled or Disabled).
Globas LBD Transmission
Timer
Displays the time interval in seconds between LBD packet transmis-
sions.
Global LBD Auto-recovery
Timer
Displays the autorecovery time period in seconds. It is the time period
that passes after which ports that were shut down through LBD are
moved to normal state.
To Next Page
Loading...
