VLAN Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 22-23
show vlan ipmvlan
Displays IPMVLAN information for a specific IPMVLAN, a range of IPMVLANs, or all the IPMVLANs.
show vlan ipmvlan [ipmvlan-id | ipmvlan-id1-ipmvlan-id2]
Syntax Definitions
ipmvlan-id Specifies the IP Multicast VLAN number. The valid range is 2–4094.
ipmvlan-id1-ipmvlan-id2 Specifies the range of the IP Multicast VLAN numbers.
Defaults
By default, the details of all the IPMVLANs will be displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the ipmvlan-id parameter with this command to display details of a specific IPMVLAN.
• Use the ipmvlan-id1-ipmvlan-id2 parameter with this command to display details of a range of
IPMVLANs.
Examples
-> show vlan ipmvlan
stree
vlan type admin oper 1x1 flat name
------+------------+-------+--------+--------------+--------------
1201 Vstk ipmtv on on on on VLAN 1201
1202 Vstk ipmtv on on off off VLAN 1202
1203 Entp ipmtv on on off off VLAN 1203
1204 Vstk ipmtv on on on on VLAN 1204
1205 Entp ipmtv on off on off VLAN 1205
-> show vlan ipmvlan 1201-1203
stree
vlan type admin oper 1x1 flat name
------+------------+-------+--------+--------------+--------------
1201 Vstk ipmtv on on on on VLAN 1201
1202 Vstk ipmtv on on off off VLAN 1202
1203 Entp ipmtv on on off off VLAN 1203
-> show vlan ipmvlan 50
Name : VLAN 50,
IPMV Mode : Enterprise IPMVLAN
Administrative State: enabled,
Operational State : disabled,
To Next Page
Loading...
