VLAN Management Commands
page 22-24 OmniSwitch 6250 CLI Reference Guide November 2009
1x1 Spanning Tree State : disabled,
Flat Spanning Tree State: disabled,
-> show vlan ipmvlan 51
Name : VLAN 51,
IPMV Mode : Vlan Stacking IPMVLAN
Administrative State : enabled,
Operational State : disabled,
1x1 Spanning Tree State : enabled,
Flat Spanning Tree State: enabled,
Release History
Release 6.6.1; command was introduced.
output definitions
vlan The IPMVLAN ID.
type Indicates if the IPMVLAN is in Enterprise mode (Entp ipmtv) or
VLAN Stacking mode (Vstk ipmtv).
admin Indicates IPMVLAN administrative status: on (enables IPMVLAN
functions to operate) or off (disables IPMVLAN functions without
deleting the IPMVLAN).
oper IPMVLAN operational status: on (enabled) or off (disabled). Opera-
tional status remains disabled until an active port is assigned to the
IPMVLAN. When operational status is enabled, IPMVLAN properties
(e.g. router interfaces, Spanning Tree) are applied to ports and traffic
flow. An IPMVLAN must have an enabled administrative status before
it can become operationally enabled.
Name The user-defined text description for the IPMVLAN. By default, the
IPMVLAN ID is specified for the IPMVLAN description.
IPMV mode Indicates the mode (Enterprise IPMVLAN or Vlan Stacking IPMV-
LAN) of the IPMVLAN.
Administrative State Indicates the administrative status of the IPMVLAN, which can be
enabled or disabled.
Operational State Indicates the operational status of the IPMVLAN, which can be
enabled or disabled.
stree 1x1 VLAN Spanning Tree status for the VLAN in the 1x1 mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the vlan stp command.
stree flat VLAN Spanning Tree status for the VLAN in the flat mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the vlan stp command.
To Next Page
Loading...
