Alcatel-Lucent OmniSwitch 6250 - Interfaces no L2 Statistics

Ethernet Port Commands
page 20-18 OmniSwitch 6250 CLI Reference Guide November 2009
interfaces no l2 statistics
Resets all statistics counters.
interfaces slot[/port[-port2]] no l2 statistics
Syntax Definitions
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• You can only configure one slot at a time. Repeat the command to configure additional slots.
• This command calls for an upper or lower case “L” character in front of the “2” character. Entering the
digit “1” (one) will result in an error message.
Examples
-> interfaces 3/1 no l2 statistics
-> interfaces 3 no l2 statistics
-> interfaces 3/1-6 no l2 statistics
Release History
Release 6.6.1; command was introduced.