Alcatel-Lucent OmniSwitch 6250 - Ip Helper Boot-Up Enable

DHCP Relay Commands
page 32-42 OmniSwitch 6250 CLI Reference Guide November 2009
ip helper boot-up enable
Specifies the type of packet to broadcast (BootP or DHCP) when automatic IP address configuration is
enabled for the switch.
Note. Automatic IP address configuration only supports the assignment of a permanent IP address to the
switch. Make sure that the DHCP server is configured with such an address before using this feature.
ip helper boot-up enable {BOOTP | DHCP}
Syntax Definitions
BOOTP Broadcasts a BOOTP formatted request packet.
DHCP Broadcasts a DHCP formatted request packet.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command is only valid if automatic IP address configuration is already enabled for the switch.
Examples
-> ip helper boot-up enable DHCP
-> ip helper boot-up enable BOOTP
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
iphelperStatTable
iphelperBootupPacketOption
parameter default
BOOTP | DHCP BOOTP
ip helper boot-up Enables or disables automatic IP configuration for the switch.