Ethernet Port Commands
page 20-88 OmniSwitch 6250 CLI Reference Guide November 2009
show interfaces hybrid traffic
Displays interface traffic statistics for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} traffic
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that statistics for the SFP port(s) will be displayed.
copper Specifies that statistics for the copper RJ-45 port(s) will be displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the traffic statistics for all switch
combo ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a slot and port number or a range of port numbers to display information for a specific combo
port or a range of combo ports.
• Enter a slot number to display information for all combo ports on a specific slot.
Examples
-> show interfaces hybrid fiber traffic
Slot/Port Input packets Input bytes Output packets Output bytes
---------+-----------------+-----------------+-----------------+-----------------
01/25 0 0 0
01/26 0 0 0
output definitions
Slot/Port Interface slot and port numbers.
Input packets Input packets detected.
Input bytes Input bytes detected.
Output packets Output packets detected.
Output bytes Output bytes detected.
To Next Page
Loading...
