RIP Commands
page 33-26 OmniSwitch 6250 CLI Reference Guide November 2009
-> show ip rip routes 2.0.0.0 255.0.0.0
Destination = 2.0.0.0,
Mask length = 8,
Gateway(1) = 5.0.0.14,
Protocol = Rip,
Out Interface = intf5,
Metric = 2,
Status = Installed,
State = Active,
Age = 19s,
Tag = 0,
Gateway(2) = 4.0.0.7,
Protocol = Rip,
Out Interface = intf4,
Metric = 3,
Status = Not Installed,
State = Active,
Age = 12s,
Tag = 0,
output definitions
Destination Destination network IP address.
Gateway The Gateway IP address (switch from which the destination address
was learned).
State The associated state of the route, which can be A (Active), H
(Holddown), or G (Garbage).
Metric Metric associated with this network. Generally, this is the RIP hop
count (the number of hops from this switch to the destination switch).
Proto The type of route (Local, Rip, or Redist).
output definitions
Destination Destination network IP address.
Mask length Length of the destination network IP subnet mask.
Gateway The Gateway IP address (switch from which the destination address
was learned).
Protocol The type of the route (Local, Rip, or Redist).
Out Interface The RIP interface through which the next hop is reached.
Metric Metric associated with this network. Generally, this is the RIP hop
count (the number of hops from this switch to the destination switch).
Status The RIP interface status (Installed or Not Installed).
State The associated state of the route (Active, Holddown, or Garbage).
Age The age of the route in seconds (the number of seconds since this route
was last updated or otherwise determined to be correct).
Tag The associated route tag.
To Next Page
Loading...
