IP Commands
page 29-60 OmniSwitch 6250 CLI Reference Guide November 2009
Usage Guidelines
• This command allows the use to enable or disable all types of ICMP messages, and set the minimum
packet gap between messages of the specified type. The ICMP message types are specified in RFC
792, and are listed below:
ICMP Message Type Code
echo reply 0 0
network unreachable 0 3
host unreachable 3 1
protocal unreachable 3 2
port unreachable 3 3
frag needed but DF bit set 3 4
source route failed 3 5
destination network unknown 3 6
destination host unknown 3 7
source host isolated 3 8
dest network admin prohibited 3 9
host admin prohibited by filter 3 10
network unreachable for TOS 3 11
host unreachable for TOS 3 12
source quench 4 0
redirect for network 5 0
redirect for host 5 1
redirect for TOS and network 5 2
redirect for TOS and host 5 3
echo request 8 0
router advertisement 9 0
router solicitation 10 0
time exceeded during transmit 11 0
time exceeded during reassembly 11 1
ip header bad 12 0
required option missing 12 1
timestamp request 13 0
timestamp reply 14 0
information request (obsolete) 15 0
information reply (obsolete) 16 0
address mask request 17 0
address mask reply 18 0
To Next Page
Loading...
