Interswitch Protocol Commands
page 14-8 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
AMAP Discovery Phase Time-
out Interval (seconds)
The number of seconds to wait between each Hello packet transmission
during the discovery phase. Use the amap discovery time command to
change this value.
Remote Host Description The system name for the adjacent switch.
Remote Host Base MAC The chassis base MAC address for the adjacent switch.
Local Interface The local switch port/VLAN that received the AMAP packet.
Remote Interface The adjacent switch port/VLAN that sent the AMAP packet.
Remote IP Address
Configured
The number of IP addresses configured on the adjacent switch. The
actual IP address values are listed below this field.
amap Enables (default) or disables AMAP on a switch.
amap discovery time Sets the discovery transmission time interval used by active Span-
ning Tree ports in the discovery transmission state.
amap common time Sets the common transmission time interval used by the active
Spanning Tree ports in the common transmission state.
output definitions (continued)
To Next Page
Loading...
