SNMP Commands
page 10-4 OmniSwitch 6250 CLI Reference Guide November 2009
• The default UDP port 162 is commonly used for traps; however, the destination port can be redefined
to accommodate an SNMP station using a nonstandard port. The destination port specified in the
command line must correspond with the UDP destination port configured at the receiving SNMP
station(s).
• When the SNMP station is enabled, the switch transmits traps to the specified IP or IPv6 address.
Examples
-> snmp station 168.22.2.2 111 username2 v1 disable
-> snmp station 168.151.2.101 "test lab"
-> snmp station 170.1.2.3 username1 enable
-> snmp station 1.1.2.2 v2
-> no snmp station 2.2.2.2
-> snmp station 300::1 enable
-> no snmp station 300::1
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
trapStationTable
trapStationIP
trapStationPort
trapStationUser
trapStationProtocol
trapStationRowStatus
alaTrapInetStationTable
alaTrapInetStationIPType
alaTrapInetStationIP
alaTrapInetStationPort
alaTrapInetStationRowStatus
alaTrapInetStationProtocol
alaTrapInetStationUser
show snmp station Displays the current SNMP station information.
To Next Page
Loading...
