Port Mobility Commands
page 21-32 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
authent The authentication status for the port (on-8021x, or off). Use the vlan
port authenticate and vlan port 802.1x commands to change this sta-
tus.
enabled The default VLAN status for the port: on enables the forwarding of
traffic that doesn’t match any rules on the port’s configured default
VLAN; off disables the forwarding of such traffic and packets are dis-
carded. Use the vlan port default vlan to change this status.
restore The default VLAN restore status for the port: on indicates that the
mobile port will not retain its VLAN assignments when qualifying traf-
fic ages out on that port; off indicates that the mobile port will retain its
dynamic VLAN assignments after qualifying traffic has aged out. Use
the vlan port default vlan restore command to change this status.
ignore BPDU The ignore BPDU status for the port: on indicates that if the mobile
port receives BPDUs, they’re ignored and the port remains eligible for
dynamic VLAN assignment; off indicates that if a BPDU is seen on the
port, mobility is disabled and the port is not eligible for dynamic
assignment. The status of ignore BPDU is set when the vlan port
mobile command is used to enable or disable mobility on a port.
show vlan port Displays VLAN port assignments for all VLANs, a specific VLAN,
or for a specific port.
output definitions (continued)
To Next Page
Loading...
