IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-81
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceStatus
alaRipngRouteTag
laRipngInvalidTimer
alaRipngGarbageTimer
alaRipngHolddownTimer
alaRipngJitter
alaRipngTriggeredSends
ipv6 rip status Enables or disables RIPng routing on the switch.
ipv6 rip route-tag Configures the route tag value for RIP routes generated by the
switch.
ipv6 rip update-interval Configures the Interval, in seconds, so that RIPng routing updates
are sent out.
ipv6 rip invalid-timer Configures the amount of time a route remains active in RIB before
being moved to the "garbage" state.
ipv6 rip invalid-timer Configures the RIPng garbage timer value. Routes move into the
garbage collection state because the timer expired or a route update
with an INFINITY metric was received.
ipv6 rip holddown-timer Configures the amount of time a route is placed in a holddown state.
ipv6 rip jitter Configures an offset value for RIPng updates. This is the maximum
(positive or negative) value that can be used to offset the update
interval.
ipv6 rip triggered-sends Configures the behavior of triggered updates.
To Next Page
Loading...
