EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6250 - Page 1403

Alcatel-Lucent OmniSwitch 6250
2018 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Health Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 36-7
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
HealthThreshInfo
healthThreshDeviceRxLimit
healthThreshDeviceTxRxLimit
healthThreshDeviceTempLimit
healthThreshDeviceMemoryLimit
healthThreshDeviceCpuLimit
output definitions
Rx Threshold The current device input (RX) threshold. This value displays the maxi-
mum percentage of total bandwidth allowed for incoming traffic on the
switch. The total bandwidth is defined as the Ethernet port capacity for
all NI modules currently operating in the switch, in Mbps. For example,
a chassis with 48 100Base-T Ethernet ports installed has a total band-
width of 4800 Mbps. The default value is 80 percent and can be
changed via the health threshold command.
TxRx Threshold The current device output/input (TX/RX) threshold. This value dis-
plays the maximum percentage of total bandwidth allowed for all
incoming and outgoing traffic. As with the RX threshold described
above, the total bandwidth is defined as the Ethernet port capacity for
all the NI modules currently operating in the switch, in Mbps. The
default value is 80 percent and can be changed via the
health threshold command.
Memory Threshold Displays the current memory usage threshold. Memory usage refers to
the total amount of RAM memory currently used by switch applica-
tions. The default value is 80 percent and can be changed via the
health threshold command.
CPU Threshold Displays the current CPU usage threshold. CPU usage refers to the total
amount of CPU processor capacity currently used by switch applica-
tions. The default value is 80 percent and can be changed via the
health threshold command.
Temperature Threshold Displays the current chassis temperature threshold, in Celsius. The
default value is 50 degrees Celsius and can be changed via the
health threshold command.
health threshold Configures thresholds for input traffic (RX), output/input traffic
(TX/RX), memory usage, CPU usage, and chassis temperature.

Table of Contents

Other manuals for Alcatel-Lucent OmniSwitch 6250

Related product manuals