QoS Commands
OmniSwitch CLI Reference Guide November 2009 page 38-23
• No changes to the filtering and shutdown options are applied to the switch until the qos apply
command is performed.
• This command only applies to ports that are members of the UserPorts group. Use the policy port
group command to create and assign members to the UserPorts group.
• An SNMP trap is sent when a port is administratively disabled through a UserPorts shutdown function
or a port disable action.
• To enable a port disabled by a user port shutdown operation, use the interfaces admin command to
administratively enable the port or disconnect and reconnect the port cable.
• Up to 126 IP interfaces are supported with spoof detection on user ports. If the number of interfaces
exceeds this amount, user port packets ingressing on those interfaces that exceed the 126 limit are
dropped.
Examples
-> qos user-port filter spoof bpdu
-> qos user-port shutdown spoof bdpu rip
-> qos no user-port shutdown
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSConfigTable
alaQoSConfigUserportFilter
alaQoSConfigAppliedUserportFilter
alaQoSConfigUserportShutdown
alaQoSConfigAppliedUserportShutdown
policy port group Configures a port group and its associated slot and port numbers.
show qos config Displays QoS configuration information.
To Next Page
Loading...
