QoS Policy Commands
page 39-6 OmniSwitch CLI Reference Guide November 2009
• If the configuration snapshot command is entered after the policy rule command is configured, the
resulting ASCII file will include the following additional syntax for the policy rule command:
from {cli | ldap | blt}
This syntax indicates how the rule was created. The cli and ldap options may be changed by a user
modifying the ASCII file; however, changing this setting is not recommended. The blt option indicates
a built-in rule, this setting is not configurable.
• The log option is useful for determining the source of attacks on the switch firewall.
• If traps are enabled for the rule, a trap is only sent when a port disable action or UserPort shutdown
operation is triggered.
Examples
-> policy rule rule2 precedence 65535
-> policy rule rule2 validity period vp01
-> no policy rule rule2
-> policy rule rule2 no precedence
-> policy rule no validity period
Release History
Release 6.6.1; command was introduced.
Related Commands
policy validity period Configures a validity period that specifies days, times, and/or months
during which an associated policy rule is in effect.
policy condition Configures condition parameters.
policy action Configures action parameters.
qos apply Applies configured QoS and policy settings to the current configuration.
show policy rule Displays information for policy rules configured on the switch.
show active policy rule Displays only those policy rules that are currently being enforced on the
switch.
To Next Page
Loading...
