QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-71
• Note that even though tcpflags can be used with most action parameters, it is mainly intended for ACL
use.
Examples
-> policy condition c1 tcpflags all f s mask f s a
-> policy condition c2 tcpflags any a r mask a r
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSConditionTable
alaQoSConditionTcpFlags,
alaQoSConditionTcpFlagsStatus,
alaQoSConditionTcpFlagsVal,
alaQoSConditionTcpFlagsValStatus,
alaQoSConditionTcpFlagsMask,
alaQoSConditionTcpFlagsMaskStatus,
alaQoSAppliedConditionTable
alaQoSAppliedConditionTcpFlags,
alaQoSAppliedConditionTcpFlagsStatus,
alaQoSAppliedConditionTcpFlagsVal,
alaQoSAppliedConditionTcpFlagsValStatus,
alaQoSAppliedConditionTcpFlagsMask,
alaQoSAppliedConditionTcpFlagsMaskStatus,
qos apply Applies configured QoS and policy settings to the current configuration.
policy condition Creates a policy condition.
show policy condition Shows information about policy conditions configured on the switch.
To Next Page
Loading...
