QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-193
-> show applied policy action
Bandwidth Max
Action Name From Disp Pri Share Min Max Depth Bufs
action1 cli accept No
action2 cli accept No
-> show policy action action*
Bandwidth Max
Action Name From Disp Pri Share Min Max Depth Bufs
action1 cli accept No
action2 cli accept No
Release History
Release 6.6.1; command was introduced.
Related Commands
output definitions
Action Name The name of the action, configured through the policy action com-
mand.
From Where the policy rule originated: cli indicates that the entry was config-
ured on the switch; ldap indicates the entry was configured through
PolicyView.
Disp The disposition of the rule, either accept or deny.
Pri The priority configured for the rule.
Share Whether or not the rule specifies that the queue should be shared.
Max Bandwidth The maximum bandwidth required by the rule.
Max Depth Bufs Maximum depth (in Kbytes) of queues for traffic.
policy action Creates a policy action. A QoS action is a particular set of bandwidth
and queue parameters that may be applied to a flow matching particular
QoS conditions.
To Next Page
Loading...
