AAA Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 43-57
-> show aaa server ldap2
Server name = ldap2
Server type = LDAP,
Host name 1 = ors40535,
Retry number = 3,
Timeout (in sec) = 2,
Port = 389,
Domain name = manager,
Search base = c=us,
RADIUS, TACACS+, and LDAP parameters are configured through the aaa radius-server,
aaa tacacs+-server, and aaa ldap-server commands. Parameters for the ACE server are automatically set
by the switch.
Release History
Release 6.6.1; command was introduced.
output definitions
Server name The name of the server. The switch automatically assigns “ace” to an
ACE server. A RADIUS, TACACS+ or LDAP server name is defined
through the aaa radius-server, aaa tacacs+-server, and aaa ldap-
server commands respectively.
Server type The type of server (ACE, LDAP, TACACS+, or RADIUS).
Host name The name of the primary LDAP, TACACS+, or RADIUS host.
IP address The IP address(es) of the server.
Retry number The number of retries the switch makes to authenticate a user before
trying the backup server.
Timeout The timeout for server replies to authentication requests.
Port The port number for the primary LDAP or TACACS+ server.
Encryption enabled
The status of the encryption.
Domain name The super-user or administrative distinguished name in the format rec-
ognized by the LDAP-enabled directory servers.
Search base The search base recognized by the LDAP-enabled directory servers.
Authentication port The UDP destination port for authentication requests.
Accounting port The UDP destination port for accounting requests.
To Next Page
Loading...
