File Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 7-57
rz
Starts a Zmodem session.
rz
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• To use Zmodem, you must have a terminal emulator that supports the Zmodem protocol.
• Activate the Zmodem transfer according to the instructions that came with your terminal emulation
software.
• When the transfer is complete, you can use the ls command to verify that the files were loaded
successfully.
• To abort a Zmodem session, enter CTRL + X five times in succession. Refer to your switch’s User
Manual for more information on uploading files via Zmodem.
• This command can also be used on the secondary CMM.
Examples
-> rz
Upload directory: /flash
rz ready to receive file, please start upload (or send 5 CTRL-X's to abort).
Release History
Release 6.6.1; command was introduced.
Related Commands
N/A
MIB Objects
systemServices
systemServicesAction
To Next Page
Loading...
