Link Aggregation Commands
page 12-22 OmniSwitch 6250 CLI Reference Guide November 2009
partner_admin_port The administrative state of the partner port. Possible values are
0–65535.
partner_admin_port_priority The priority of the partner port. Possible values are 0–255.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a slot and port from a dynamic aggregate group.
• Mobile ports cannot be aggregated.
• A port may belong to only one aggregate group.
• Ports in a dynamic aggregate must all be in the same speed (e.g., all 100 Mbps. 1 Gigabit. or all 10
Gigabit).
• Ports that belong to the same dynamic aggregate group do not have to be configured sequentially and
can be on any Network Interface (NI).
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg 3/1 actor admin key 0
-> lacp agg no 3/1
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alclnkaggAggPortTable
alclnkaggAggPortGlobalPortNumber
alclnkaggAggActorAdminKey
alclnkaggAggPortLacpType
alclnkaggAggPortActorAdminState
alclnkaggAggPortActorSystemID
parameter default
[active] [timeout] .... active, timeout, aggregate
lacp linkagg size Creates a dynamic aggregate group.
show linkagg port Displays information about ports associated with a particular aggregate
group or all aggregates.
To Next Page
Loading...
