Alcatel-Lucent OmniSwitch 6250 - Page 447

Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-7
• Note that when changing the protocol to/from MSTP, the bridge priority and port path cost values for
the flat mode CIST instance are reset to their default values. However, if the path cost mode was set to
32-bit prior to the protocol change, the path cost is not reset to its default value. See the bridge path
cost mode command page for more information.
Examples
-> bridge mode flat
-> bridge protocol mstp
-> bridge protocol rstp
-> bridge protocol stp
-> bridge mode 1x1
-> bridge 10 protocol rstp
-> bridge 200 protocol stp
-> bridge protocol mstp
-> bridge protocol rstp
-> bridge protocol stp
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsTable
vStpInsNumber
vStpInsMode
vStpInsProtocolSpecification
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge cist protocol Explicit command for changing the Spanning Tree protocol for the flat
mode instance.
bridge 1x1 protocol Explicit command for changing the Spanning Tree protocol for a VLAN
instance.