Distributed Spanning Tree Commands
page 16-22 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> bridge mode flat
-> bridge priority 8192
-> bridge priority 2500
ERROR: Valid bridge priority values are multiples of 4096: 0, 4096,
8192, 12288, 16384 ... 61440
-> bridge mode 1x1
-> bridge 255 priority 16384
-> bridge 355 priority 3500
-> bridge priority 8192
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsTable
vStpInsNumber
vStpInsMode
vStpInsPriority
vStpInsBridgeAddress
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge cist priority Explicit command for changing the Spanning Tree priority for the CIST
instance when the switch is operating in either the flat or 1x1 mode.
bridge msti priority Explicit command for changing the Spanning Tree priority for an MSTI
when the switch is operating in either the flat or 1x1 mode.
bridge 1x1 protocol Explicit command for changing the Spanning Tree priority for a VLAN
instance when the switch is operating in either the flat or 1x1 mode.
To Next Page
Loading...
