Alcatel-Lucent OmniSwitch 6250 - Page 504

Distributed Spanning Tree Commands
page 16-64 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> bridge mode flat
-> bridge msti 0 1/24 priority 12
-> bridge msti 2 1/24 priority 5
-> bridge mode 1x1
-> bridge msti 0 1/24 priority 12
-> bridge msti 2 1/24 priority 5
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortPriority
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge slot/port priority Implicit command for configuring the Spanning Tree priority value for a
port or an aggregate of ports that applies to the specified CIST or VLAN
instance.
bridge cist slot/port priority Explicit command for configuring the Spanning Tree priority value for a
port or an aggregate of ports for the CIST instance when the switch is
operating in either the 1x1 or Tree mode.
bridge 1x1 slot/port priority Explicit command for configuring the Spanning Tree priority value for a
port or an aggregate of ports for a VLAN instance when the switch is
operating in either the 1x1 or flat mode.