Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-77
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortPathCost
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge slot/port path cost Implicit command for configuring the Spanning Tree path cost value for
a port or an aggregate of ports that applies to the specified CIST or
VLAN instance.
bridge cist slot/port path cost Explicit command for configuring the Spanning Tree path cost value for
a port or an aggregate of ports for the CIST instance when the switch is
operating in either the 1x1 or flat mode.
bridge 1x1 slot/port path cost Explicit command for configuring the Spanning Tree path cost value for
a port or an aggregate of ports for a VLAN instance when the switch is
operating in either the 1x1 or flat mode.
To Next Page
Loading...
