Distributed Spanning Tree Commands
page 16-100 OmniSwitch 6250 CLI Reference Guide November 2009
Examples
-> bridge mode flat
-> bridge 1x1 3 15 auto-edge on
-> bridge 1x1 255 8/23 auto-edge disable
-> bridge mode 1x1
-> bridge 1x1 4 2/2 auto-edge enable
-> bridge 1x1 255 10 auto-edge off
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortAutoEdge
bridge mode Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
bridge cist slot/port auto-edge Configures whether or not Spanning Tree automatically determines the
operational edge status of a port or an aggregate of ports for the flat
mode CIST instance.
bridge cist slot/port admin-edge Configures the administrative edge port status for a port or aggregate
of ports for the CIST instance.
bridge 1x1 slot/port admin-edge Configures the administrative edge port status for a port or an aggre-
gate of ports for a specific VLAN instance.
To Next Page
Loading...
