Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-125
Release History
Release 6.6.1; command was introduced.
Related Commands
Forward Delay The amount of time (in seconds) that a port will remain in the Listening
state and then the Learning state until it reaches the forwarding state.
This is also the amount of time used to age out all dynamic entries in
the Forwarding Database when a topology change occurs. Configured
through the bridge forward delay command.
Hello Time The amount of time (in seconds) between the transmission of Configu-
ration BPDUs on any port that is the Spanning Tree root or is attempt-
ing to become the Spanning Tree root. Configured through the bridge
hello time command.
System Max Age The Max Age value for the root bridge.
System Forward Delay The Forward Delay value for the root bridge.
System Forward Delay The Forward Delay value for the root bridge.
show spantree Implicit command for displaying the Spanning Tree bridge configu-
ration for the flat mode CIST instance or a 1x1 mode VLAN
instance.
show spantree msti Explicit command for displaying the Spanning Tree bridge configu-
ration for an MSTI regardless of which mode (1x1 or flat) is active
on the switch.
show spantree 1x1 Explicit command for displaying the Spanning Tree bridge configu-
ration for a VLAN instance regardless of which mode (1x1 or flat)
is active on the switch.
output definitions (continued)
To Next Page
Loading...
