Port Mobility Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 21-17
• IP protocol rules (ipE2 and ipSnap) also capture DHCP traffic, if no other DHCP rule exists that would
classify the DHCP traffic into another VLAN. Therefore, it is not necessary to combine DHCP rules
with protocol rules for the same VLAN.
• Rules are only assigned to existing VLANs. Use the vlan command to create a new VLAN.
Examples
-> vlan 10 protocol ip-e2
-> vlan 30 protocol ethertype 0600
-> vlan 40 protocol dsapssap F0/F0
-> vlan 50 protocol snap 6004
-> vlan 10 no protocol ip-snap
-> vlan 30 no protocol ethertype 0806
-> vlan 40 no protocol dsapssap 04/04
-> vlan 50 no protocol snap 80FE
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
vProtocolRuleTable
vProtoRuleProtoClass
vProtoRuleEthertype
vProtoRuleDsapSsap
vProtoRuleVlanId
vProtoRuleStatus
show vlan Displays existing VLANs.
show vlan rules Displays rules defined for VLANs.
To Next Page
Loading...
