VLAN Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 22-21
Release History
Release 6.6.1; command was introduced.
Related Commands
stree 1x1 VLAN Spanning Tree status for the VLAN in the 1x1 mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the vlan stp command.
stree flat VLAN Spanning Tree status for the VLAN in the flat mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the vlan stp command.
ip IP router interface status: on (IP interface exists for the VLAN) or off
(no IP router interface exists for the VLAN). Use the ip interface com-
mand to define an IP router interface for a VLAN.
mble tag Mobile tagging status: on (enabled); off (disabled). Configured through
the vlan mobile-tag command.
name The user-defined text description for the VLAN. By default, the VLAN
ID is specified for the VLAN description.
show vlan Displays a list of VLANs configured on the switch.
show vlan port Displays VLAN port assignments.
output definitions (continued)
To Next Page
Loading...
