Chassis Management and Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 2-37
Release History
Release 6.6.1; command was introduced.
Related Commands
Manufacture Date The date the board was manufactured.
Firmware Version The firmware version for the board’s ASICs.
Admin Status The current power status of the CMM. Because information is obtained
from a running CMM, the value will always be POWER ON.
Operational Status The current operational status of the CMM.
Power Consumption The current power consumption for the CMM.
Power Control Checksum The current power control checksum for the corresponding CMM.
MAC Address The MAC address assigned to the chassis. This base chassis MAC
address is a unique identifier for the switch and is stored on an
EEPROM card in the chassis. It is not tied to the CMM. Therefore, it
will not change if the CMM is replaced or becomes secondary. The
MAC address is used by the Chassis MAC Server (CMS) for allocation
to various applications. Refer to the “Managing MAC Addresses and
Ranges” chapter of the OmniSwitch 6250 Switch Management Guide
for more information.
show chassis Displays the basic configuration and status information for the switch
chassis.
show ni Displays the basic hardware and status information for Network Inter-
face (NI) modules currently installed in the switch.
show module Displays the basic information for either a specified module or all the
modules installed in the chassis.
show module long Displays the detailed information for either a specified module or all
modules installed in the chassis.
show module status Displays the basic status information for either a specified module or all
modules installed in the chassis.
show system Displays basic system information for the switch.
output definitions (continued)
To Next Page
Loading...
