Keysight x-series Instruction Manual

8 Trigger
8.1 Trigger
except ACP
In WLAN, all measurements
In Phase Noise, all measurements except Log Plot and Spot Frequency
"ADC Trigger" on page
2329
ADC
All Modes and measurements supporting Video or Level, except Spectrum
Analyzer mode
Only supported in certain model’s IF Paths
"Line" on page 2330
LINE
All Modes except EMI, Avionics and Analog Demod
In Spectrum Analyzer, all measurements except List Sweep
In WLAN and GSM/EDGE, all measurements except Power vs. Time
In LTE and 5G NR, all measurements except Transmit On/Off Power
In Short Range Comms, all measurements except Modulation Analysis
In MSR, all measurements
Level [Mode: RTSA,
PULSEX]
LEVel
RTSA and Pulse Modes only
FMT [Mode: RTSA,
PULSEX]
FMT
RTSA and Pulse Modes only
"External 1" on page
2330
EXTernal1
All Modes and measurements
"External 2" on page
2331
EXTernal2
All Modes and measurements
"External 3" on page
2332
EXTernal3
See "External 3 Support" on page 2318
"RF Burst" on page 2333
RFBurst
All Modes except EMI
In Spectrum Analyzer, all measurements except List Sweep
"Periodic" on page 2334
FRAMe
All Modes except EMI
In Spectrum Analyzer, all measurements except List Sweep
TV [Mode: SA]
TV
Spectrum Analyzer Mode only, and only in the Swept SA measurement
2317 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)