8 Trigger
8.1 Trigger
I/Q Triggers
"I/Q Mag" on page 2336
IQMag
All Modes except EMI, Avionics, RTSA, Analog Demod and Pulse
In Spectrum Analyzer, only in Power Stat CCDF and Burst Power
In WCDMA, only in Power Stat CCDF and IQ Waveform
In GSM/EDGE, only in EVM, GMSK Phase & Freq Error, Transmit
Power and IQ Waveform
In Phase Noise, only in IQ Waveform
In Bluetooth, only in Transmit Analysis
In LTE, only in Power Stat CCDF, Modulation Analysis, Conformance
EVM, and IQ Waveform
In WLAN, only in Power Stat CCDF, Modulation Analysis, Spectral
Flatness, and IQ Waveform
In Short Range Comms, only in Power Stat CCDF and Modulation
Analysis
In VMA, only in Power Stat CCDF, Digital Demod and IQ Waveform
In CQM, only in Group Delay, Power Stat CCDF, and IQ Waveform
"Input I" on page 2336
IINPut
"Input Q" on page 2337
QINPut
"I (Demodulated)" on page
2337
IDEMod
"Q (Demodulated)" on page
2338
QDEMod
"Aux I/Q Mag" on page
2338
AIQMag
"PXI" on page 2339
PXI
All Modes and measurements (only found in modular analyzers)
"Internal" on page 2339
INTernal
All Modes and measurements (only found in modular analyzers)
"Audio External" on page
2333
AEXTernal
Via the TRIG IN connector on the M9260A Audio Analyzer module
"Prot Channel Detection"
on page 2340
PRTChandet
Base Station Emulation; valid UL signal detected
(PUSCH/PUCCH/PRACH/SRS)
"Prot Frame Aligned" on
page 2340
PRTFrame
Base Station Emulation; periodic technology format radio frame with
data frame aligned to the BSE timing
"Prot Event" on page 2341
PRTEvent
Base Station Emulation events
External 3 Support
Trigger Source External 3 is available only in certain Modes and measurements, as
follows:
5GNR
Transmit On|Off, Modulation Analysis, Power Stat CCDF, and IQ Waveform measurements only
ADEMOD
Not supported
AVIONICS
Not supported
BT
Not supported
CQM
Group Delay, Power Stat CCDF, and IQ Waveform measurements only
EMI
Not supported
GSMEDGE
IQ Waveform and Transmit Power measurements only
LTEAFDD,
Power Stat CCDF, IQ Waveform, and Transmit On|Off measurements only
Short Range Comms & IoT Mode User's &Programmer's Reference 2318