Keysight x-series Instruction Manual

8 Trigger
8.1 Trigger
Meas Mode Preset for RF Preset for IQ
EDGE EVM
EDGE/GSM
RFB IQM
EDGE ORFS
EDGE/GSM
Periodic Timer IQ not
supported
Combined
WCDMA
WCDMA
IMM
IQ not
supported
Combined
GSM
EDGE/GSM
RFB
IQ not
supported
List Power Step
WCDMA, EDGE/GSM
IMM
IQ not
supported
Transmit
On/Off
Power
LTETDD, LTEATDD, 5GNR
BTS: External 1
(External3 when IFBW ≥ 256
MHz with H1G option)
MS: Periodic Timer
BTS: EXT1
MS: FRAM
Transmit Analysis
BLUETOOTH
RFB
IQ not
supported
Adjacent Channel
Power
BLUETOOTH
IMM
IQ not
supported
LE In-band
Emissions
BLUETOOTH
IMM
IQ not
supported
EDR In-band
Spurious Emissions
BLUETOOTH
Periodic Timer IQ not
supported
Conformance EVM
LTEAFDD, LTEATDD, MSR
IMM IMM
Spectrum & PvT
RTSA IMM
IQ not
supported
Pulse
PULSEX IMM
IQ not
supported
AM, FM, PM, FM
Stereo
ADEMOD IMM
IQ not
supported
PAvT
SA, 5GNR, VMA IMM IMM
Group Delay
CQM IMM IMM
RF Trigger Source (Remote Command Only)
Selects the trigger to be used for the specified measurement when RF is the
selected input. The RF trigger source can be queried and changed even while
another input is selected, but it is inactive until RF becomes the selected input.
Note the inclusion of the <measurement> parameter in the command below.
Because each measurement remembers its own Trigger Source, the command must
be qualified with the measurement name. Note that for the Swept SA measurement
2325 Short Range Comms & IoT Mode User's &Programmer's Reference

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)